We make bespoke, made to measure covers based
upon the measurements you supply during checkout.
The measurements we ask you for are the width and length of your ironing board surface in cm.
Please do not not include the ironing plate or
the
depth of the sides in your measurements.
Please measure your ironing
board rather than using the measurement guide from a previous cover.
We cut and sow each cover by hand and we aim to send out your cover within 28 working days, but please remember that this is a made to measure service not mass production. An order may on occasion take a little over the 28 days. Please take this into consideration when placing your order.
If you have a different or
unusual shaped board which is not a shirtmaster or a standard bullet shaped board, please draw a paper template around the board (newspaper will be fine). We will use this as a guide to cut your cover and we will add on the extra fabric to fit under the board. Please write TOP Pattern on the upside (fabric pattern side) of the template, if this is incorrect the cover will have to be replaced at your own cost. Please specify if you wish the cover to be a drawstring or elasticated fit. Please also write your name and address, design and quantity on the template.
Please post your template and order to the postal address given below.
A cover made to a template costs £10 + £2 p&p.
|
We accept Visa, Master Card, Maestro and Solo.
|
|
Ironingboardcovers
5 Groomfield Close
Tooting Bec
London
SW17 8DH
Please include the following information;
1. Your name
2. Your delivery address & telephone number
3. The name of the design you would prefer
4. The size of your ironing board surface in cm
5. A cover costs £10 plus £2.00 P&P per whole order.Please
remember to enclose a cheque for the full amount, made payable to Ironingboardcovers.
Please allow up to 28 working days for delivery.
We are unable to accept orders by phone. |
Click on the PDF or Word icon to print a postal order form.
 
|
